Great Planes Giant Scale 38% Extra 330S ARF GPMA1290

This is the radio controlled, gasoline powered, Almost Ready to Fly, Great Planes 38% Extra 330S Giant Scale Aerobat. IMAA Legal and Fully 3D and IMAC Capable For Advanced Modeler/Fliers.

Features

• Great Planes Giant Scale 38% Extra 330S ARF GPMA1290

• Construction: Built-up balsa and ply airframe, sheeted foam turtle deck with balsa sheeting, full deflection throws and double beveled control surfaces

• Wings: Two-piece wing panels with aluminum joiner tube

• Horizontal Stabilizer: Two-piece with carbon fiber joiner tube

• Radio Compartment: Located under canopy, plywood reinforced

• Covering: Top Flite MonoKote

• Cowl: Carbon-fiber/fiberglass, painted to match covering

• Cockpit Detail: Instrument panel and painted pilot head

• Canopy: Clear, integrated with hatch, removal allows access to electronics and battery packs

• Landing Gear: Carbon-fiber

• Main Wheels: 5" (217mm) Du-Bro, constructed of rubber

• Tailwheel: Adjustable aluminum

• Landing Gear Fairings: Painted fiberglass

• Aileron Control: Four servo, prehinged with giant scale hinge point hinges

• Pilot Figure: Lightweight painted fiberglass

• Fuel Tank: 49oz (1450cc)

• Spinner: Polished aluminum 4" (102mm) diameter

• Stabilizer: Bolt-on halves with prebuilt servo pockets, carbon fiber tubes

• Rudder: Pull-pull design with three servo set-up, dual ball bearing supported tiller arm and aluminum servo tray

• Hardware: Complete giant scale set with all-aluminum servo arms (normally an extra-cost add-on)

• Building Time: Ready to fly in 6-8 hours

• Warranty: Great Planes Model Manufacturing Company guarantees this kit free from defects in both materials and workmanship at the date of purchase.

Specifications

• Wingspan: 110.5" (2805mm)

• Wing Area: 2279 sq in (147 sq dm)

• Weight: 36 - 38lb (16.3 - 17.2kg)

• Wing Loading: 36 - 38 oz/sq ft (111 - 117g/sq dm)

• Length: 103" (2616mm)

• Airfoil: Fully symmetrical

• Center of Gravity: 5-3/4" (146mm) Back from the wing's leading edge measured at the wing tips

• Control Throws- Low Rate High Rate 3D

• Ailerons: Up & Down 1-3/8" (35mm) 2" (50mm) 3-1/2" (90mm)

• Elevator: Up & Down 1" (25mm) 1-3/4" (45mm) 4-3/4" (120mm)

• Rudder: Right & Left 5" (130mm) 7" (180mm) 8" (200mm)

Contents

• Pre-built and covered wing and fuselage sections, aluminum spinner, instrument panel, wheel pants, wheels, all hardware including aluminum servo arms and servo tray, pilot head, and manual

Requirements

• Engine: (120 -150 cc) gasoline, Desert Aircraft 150cc recommended

• Propeller: 30x12 (not carried)

• Radio: 5-6 channel with mixing capabilities

• Servos: 4-Aileron servos with at least 190 oz-in torque (FUTM0215) 3-Rudder servos with at least 120 oz-in torque (FUTM0235) 2-Elevator servos with at least 300 oz-in (FUTM0216) 1-Thottle servo medium torque (FUTM0075)

• Servo Synchronizer: FUTM4155, for the three rudder servos

• Two 6" (150mm) Heavy Duty Dual Servo Extension: (FUTM4135) from receiver for ailerons

• Two 6" (150mm) Heavy Duty Servo Extensions: (HCAM2701) for throttle servo and rudder synchronizer

• Two 12" (305mm) Heavy Duty Servo Extensions: (HCAM2711) for inboard aileron servos

• Two 36" (915mm) Heavy Duty Servo Extensions (HCAM2726) for outboard aileron servos

• If connecting elevator servos to separate channels in receiver and using mixing in transmitter the following extensions will also be required:

• Two 6" (150mm) Heavy Duty Servo Extensions: (HCAM2701)

• Two 12" (305mm) Heavy Duty Servo Extensions: (HCAM2711)

• Two 36" (915mm) Heavy Duty Servo Extensions (HCAM2726)

• If connecting elevator servos to the same channels in receiver the following will be required:

• Two 36" (915mm) Heavy Duty Servo Extensions (HCAM2726)  Servo Reverser: FUTM4150

• Receiver Battery: At least 3000mAh capacity (HCAM6355)

• Two Heavy Duty On/Off Switches: Ignition battery and radio system (HCAM2761)

• Misc. Items: CA and epoxy glue, gasoline fueler valve, 1/2" foam rubber padding, 3' medium gasoline tubing, fuel filter, propeller, decals, building and field equipment.

Comments

• Following are the Top Flite MonoKote colors used on this model and order numbers for 6ft rolls;

• Yellow, TOPQ0203 Metallic Blue, TOPQ0402 Missile Red, TOPQ0201 Aluminum, TOPQ0205