Great Planes Cap 580 Matt Chapman FlatOut 3D EP ARF GPMA1112

This is a radio controlled, electric powered, foam Great Planes FlatOuts Matt Chapman CAP 580 3D Profile Park Flyer Airplane. For Intermediate to Advanced Modeler/Fliers.

Features

• Great Planes Cap 580 Matt Chapman FlatOut 3D EP ARF GPMA1112

• Construction: 1/8" (3mm) thick foam with carbon fiber reinforcing rods to strengthen the infrastructure

• Trim: Yellow with Blue, Orange, Green and Purple splatter marks

• Wings: 1/8" (3mm) thick foam with with carbon fiber leading edge and trailing edge reinforcement

• Landing gear: Carbon fiber rods and composite axle supports

• Wheel Pants: 1/4" (6mm) thick White foam construction

• Building Time: Flight ready in 2-3 hours

• Hardware: Carbon fiber pushrods and wing struts, clip-hinge system on tail section allows up to 80° of deflection without binding and also pops loose in the event of a crash

• Motor: T-370 size Brushed

• Gearbox: 5:1 gear ratio, ball bearing-supported

• Propeller: 10x3.8 Slo-Flyer with prop saver

• Warranty: Great Planes Model Manufacturing Company guarantees this kit free from defects in both materials and workmanship at the date of purchase.

Specifications

• Wingspan: 36" (915mm)

• Wing Area: 222 sq in (14 sq dm)

• Weight: 7.5 - 9oz (215 - 225g)

• Wing Loading: 4.9-5.8oz/sq ft (15-18g/sq dm)

• Length: 30.5" (770mm)

• Airfoil: Flat plate

• Center of Gravity: 2.25" (57mm) Back from the wing's leading edge at the fuselage sides.

• Control Throws:

• Function High rate endpoints High rate travel High rate exponential

• Aileron +/- 100% +/- 55-60° 40%

• Elevator +/- 100% +/- 55-60° 40%

• Rudder +/- 100% +/- 55-60° 40%

• Low rate endpoints Low rate travel Low rate exponential

• Aileron +/- 40% +/- 15-25° 0%

• Elevator +/- 40% +/- 15-25° 0%

• Rudder +/- 40% +/- 15-25° 0%

Contents

• Cap 580 foam construction 3D airplane, 370 size motor, 5:1 gearbox, 10x3.8 Slo-Flyer prop, prop saver, carbon fiber rods and tubes, complete hardware package and photo-illustrated manual

Requirements

• Speed Control: 7+A continuous current

• Battery: 3S 350-700mAh Lithium Polymer (LiPo) battery

• **For optimum performance battery weight should not exceed 2.3oz (65g).**

• Charger: Lithium Polymer capable

• Radio: 4-channel

• Receiver: Ultra micro size

• Servos: 3 micro with a 15+ oz-in minimum torque rating

• Misc. Items: Foam-safe CA, building and field equipment

Comments

• Only one ultra micro receiver is required depending on the channel of the radio selected (Low band Ch 11-35, High band Ch 36-60). Please note the Accessory Completion Guide lists both Low and High band receivers. Channel selection is left to the modeler's preference.